hanseatic HHI8F2BSF Gebrauchsanleitung Seite 57

5. Touch and hold the Minus sensor
the timer indicator shows "
Each touch of the sensors
reduces or increases the time by 1
minute. Touching and holding the sensors
or reduces or increases the time by 10
minutes.
If you would like to amend the set time
in the interim, you will need to repeat
all of the steps.
Cooking time limits for several
cooking zones
You can set a cooking time limit for all 4 cook-
ing zones. The individual cooking times can
be of different lengths.
The timer indicator always shows the lowest
time set for a cooking zone.
Example: For cooking zone 1, a time of 5 min-
utes is set; for cooking zone 2, a time of 20
minutes is set.
Requirement: The hob is switched on.
1. Set the cooking time limit for cooking
zone 1 to 5 minutes (see „Cooking time
limit for one cooking zone" on page EN-20).
2. Then touch the cooking zone sensor (7)
for cooking zone 2.
3. Set the desired heat level.
4. Set the cooking time limit for cooking
zone 2 to 20 minutes.
Using and caring for the hob
until
".
00
The timer indicator will show the time you
have set for cooking zone 1.
or
The red dot next to the cooking zone indicator
shows that a cooking time limit has been set
for these cooking zones.
A flashing dot means that the timer indicator
is showing the cooking time limit for this cook-
ing zone. For this cooking zone, the lowest
cooking time limit is currently set.
Touching a cooking zone sensor will display
the cooking time limit for the corresponding
cooking zone.
Once the set time has elapsed, cooking zone
1 will switch off automatically and the residual
heat indicator "
start to flash next to the indicator for cooking
zone 2.
The timer indicator will now show the remain-
ing time for cooking zone 2.
0 2
3
6
H
6
" will light up. The red dot will
H
5 1
page EN-21