Safety Instructions - Ferm CDM1048 Gebrauchsanweisung

14
CORDLESS DRILL
THE NUMBERS IN THE FOLLOWING TEXT
CORRESPOND WITH THE PICTURES AT PAGE 2
TECHNICAL DATA
Voltage
Charger voltage
Charger frequency
Battery output
Charging time
Drill speeds
Max. torque (low speed)
No-load speed
Chuck capacity
Weight (incl. battery)
Lpa (sound pressure)
Vibration
PRODUCT INFORMATION
Fig. A
1 On/off switch
2 Direction switch
3 Torque setting ring
4 Chuck
5 Battery
CONTENTS OF CARRYING CASE
The carrying case contains:
1 Cordless drill
1 FEASB-14.4 battery
1 FEASL-14.4 battery charger
1 Operating instructions
1 Warranty card
Check the appliance, any loose parts and accessories for
damage caused during transport.
Ferm Ferm

SAFETY INSTRUCTIONS

When using electric machines always observe the safety
regulations applicable in your country to reduce the risk
of fire, electric shock and personal injury. Read the
following safety instructions and also the enclosed safety
instructions.
Keep these instructions in a safe place!
1. Keep work area clear.
Cluttered areas and benches invite injuries.
2. Consider work area environment.
Do not expose power tools to rain. Do not use power
| 14.4 V —
tools in damp or wet locations. Keep work area well lit.
---
Do not use power tools in presence of flammable liquids
| 230 V
| 50 Hz or gases.
3. Guard against electric shock.
| 1.0 Ah
| 3 - 5 hour Prevent body contact with grounded surfaces (e.g. pipes,
| 1 radiators, refrigerators).
4. Keep visitors away.
| 12 Nm
| 0-550/min Visitors should be kept away from the work area at all
times. Do not let visitors handle the Electric Rotary
| 0.8-10 mm
| 1.56 kg Hammer Drill at any time.
| < 75 dB(A) 5. Store unused tools.
When not is use keep tools out of reach of children. Store
| < 2.5 m/s 2
in a dry and secure location.
6. Do not force tool.
Do not apply undue pressure as this may affect
performance and may cause damage to the machine.
Forcing the job also increases the potential for accidents.
7. Use right tool.
Do not force small tools or attachments to do the job of
heavy duty tool. Do not use a tool for purposes not
intended.
8. Dress properly.
Do not wear loose clothing or Jewellery. They can be
caught in moving parts. Rubber gloves and nonskid
footwear are recommended when working outdoors.
Wear protective hair covering to contain long hair.
9. Use safety glasses.
Also use face or dust mask when operation is dusty.
10. Connect dust extraction equipment
If devices are provided for the connection of dust
extraction and collection facilities ensure these are
connected and properly used.
11. Do not abuse cord.
Never carry tool by cord or yank it to disconnect it from
electrical socket. Keep cord from heat, oil and sharp
edges.
12. Secure work.
Use clamps or a vice to hold work. It's safer than using
your hand and it frees both hands to operate tool.
13. Do not overreach.
Keep proper footing and balance at all times.
14. Maintain tools with care.
Keep tools sharp and clean for better and safer
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically and,
if damaged, have repaired by authorized service facility.
Inspect extension cords periodically and replace if
damaged. Keep handles dry, clean and free from oil and
grease.
15. Disconnect tools.
When not in use, before servicing and when changing
accessories such as blades, bits and cutters.
3