Safety Instructions; Description (Fig. A) - Ferm CDM1074 Originalbetriebsanleitung

2. SaFEty InStRuCtIOnS

Explanation of the symbols

DESCRIPtIOn (FIg. a)

Denotes risk of personal injury, loss of
life or damage to the tool in case of
non-observance of the instructions in
this manual.
Indicates electrical shock hazard.
The number of revolutions of the
machine can be electronically set.
Do not use in rain.
Indoor use only
In case of failure, the transformer is not
dangerous
Do not dispose of in household waste.
Specific safety instructions
• This appliance is not intended for use by
persons (including children) with reduced
sensory or mental capabilities, or lack of
experience and knowledge, unless they have
been given supervision or instructions
concerning use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
hold power tool by insulated gripping
surfaces, when performing an operation
where the cutting accessory may contact
hidden wiring or its own cord.
Cutting accessory contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Important safety notes on charger and internal
battery
If you come in contact with acid from the
battery, rinse it off with water
immediately. If acid gets into your eyes,
rinse out your eyes at once with water
and contact a doctor immediately!
1. Read and note the operating instructions and
safety notes for the charger and internal
battery before use!
2. NB! Only use the charger that was supplied by
the manufacturer - otherwise you will risk an
accident.
3. Protect the charger and power tool from
moisture, e.g. rain or snow.
4. Always check that all cables are connected
correctly before using the charger.
5. If you discover that a cable is damaged, you
should not use the charger again. Have the
damaged cable replaced immediately.
6. When the charger is not in use, the mains plug
should be removed from the power socket. Do
not pull out the plug by grasping the cable.
7. If the charger has been dropped or has
otherwise been exposed to high mechanical
stresses, you should have it checked for
damage by an authorized dealer before using
it again. Damaged parts should be repaired.
8. Exercise caution when handling the tool and
do not drop it or expose it to impacts.
9. Never attempt to repair the charger or internal
battery yourself. Repairs must always be
carried out by an authorized dealer - otherwise
you risk an accident.
10. Before cleaning or servicing the charger,
always pull the plug from the charger socket.
11. Never charge the tool when the ambient
temperature is below 5° C or above 40° C.
12. Never throw the tool onto a fire or into water.
This will risk explosion!
Electrical safety
Always check that the voltage on the
battery pack corresponds to the voltage
on the rating plate. Also check that your
mains voltage corresponds to the input
voltage of the battery charger.
Class II machine - Double insulation -
You don't need any earthed plug.
5