Beko CSS 66000 G Gebrauchsanleitung Seite 24

Replacing the oven lamp
DANGER:
Before replacing the oven lamp, make
sure that the product is disconnected
from mains and cooled down in order to
avoid the risk of an electrical shock.
Hot surfaces may cause burns!
The oven lamp is a special electric light bulb
that can resist up to 300 °C. See Technical
1 Front door specifications, page 11 for details. Oven
2 Hinge lamps can be obtained from Authorised
a Service Agents.
æ Position of lamp might vary from the figure.
If your oven is equipped with a round lamp:
1. Disconnect the product from mains.
2. Turn the glass cover counter clockwise to
5 _ Move the front ber to half-way.
4, Remove the front door by pulling it upwards
to release it from the right and left hinges.
[Steps carried out during removing process
ishould be performed in reverse order to
install the door. Do not forget to close the
clips at the hinge housing when reinstalling
clockwise and replace it with the new one.
4. Install the glass cover.
24/EN