Werbung
Verfügbare Sprachen
Verfügbare Sprachen
e
Product must be placed directly on the floor.
It must not be placed onto a base or a
pedestal.
"Do not use the door and/or handle to carry
Jor move the product. The door, handle or
hinges get damaged.
Electrical connection
Connect the product to a grounded outlet/line
protected by a fuse of suitable capacity as stated
in the "Technical specifications" table. Have the
grounding installation made by a qualified
electrician while using the product with or
without a transformer. Our company shall not be
liable for any damages that will arise due to
using the product without a grounding installation
in accordance with the local regulations.
\ The product must be connected to the
mains supply only by an authorised and
qualified person. The product's
warranty period starts only after correct
installation.
Manufacturer shall not be held responsible
for damages arising from procedures
carried out by unauthorised persons.
The power cable must not be clamped,
bent or trapped or come into contact
with hot parts of the product.
A damaged power cable must be replaced
by a qualified electrician. Otherwise, there is
risk of electric shock, short circuit or fire!
The mains supply data must correspond to the
data specified on the type label of the product.
The rating plate is either seen when the door or
the lower cover is opened or it is located at the
rear wall of the unit depending on the unit type.
Power cable of your product must comply with
the values in "Technical specifications" table.
electrical installation, disconnect the
product from the mains supply.
There is the risk of electric shock!
Connecting the power cable
1. If a power cable is not supplied together
with your product,a power cable that you
would select from the table (Technical
specifications, page 11) in accordance with
the electrical installation at your home must
be connected to your product by following
the instructions in cable diagram.
If it is not possible to disconnect all poles in the
supply power, a disconnection unit with at least 3
mm contact clearance (fuses, line safety
switches, contactors) must be connected and all
the poles of this disconnection unit must be
adjacent to (not above) the product in
accordance with IEE directives. Failure to obey
this instruction may cause operational problems
and invalidate the product warranty.
|
Additional protection by a residual
current circuit breaker is
recommended.
2. Open the terminal block cover with a
screwdriver.
3. Insert the power cable through the cable
clamp below the terminal and secure it to the
main body with the integrated screw on cable
clamping component.
4, Connect the cables according to the supplied
=
220/ Mam
IS
A
5 After completing the wire connections, T
the terminal block cover.
13/EN
Werbung
