Changing The Light Bulb; Regulations, Standards, Guidelines - AEG SANTO 75438 KG Gebrauchsanweisung

Changing the light bulb

Warning! There is a risk of electric shocks! Before changing the light bulb,
switch off the appliance and unplug it, or pull the fuse or the circuit
breaker. Light bulb data: 220-240 V, max. 15 W
1. To switch off the appliance, unplug the mains plug.
2. To change the light bulb, it becomes
necessary to replace the lamp,
pressing as shown in the figure.
3. Replace the lamp with one of the
same power (the maximum power
is shown on the light diffuser).
undo the screw.
4. Change the defective light bulb
with one of the same power (the
maximum power is shown on the
light diffuser).
5. Put the refrigerator back into
operation.

Regulations, Standards, Guidelines

This appliance was designed for household use and was manufactured in
accordance with the appropriate standards. The necessary measures in
accordance with appliance safety legislation regulations (GSG), accident
prevention regulations for refrigeration appliances (VBG 20) and the
regulations of the German Society of Electrical Engineers (VDE) were
observed in the manufacture of this appliance.
The refrigerant circuit has been checked for leaks.
This appliance is in accordance with the following EU guidelines:
– 73/23/EWG dated 19 February 1973 - low voltage guidelines.
– 89/336/EWG dated 3 May 1989
(including guideline change notice 92/31/EWG) - EMV guideline
Downloaded from Fridge-Manual.com Manuals
28