Troubleshooting; Possible Cause - Scheppach Basa 3 Original Bedienungsanleitung

17. Troubleshooting

Failure

Possible cause

Motor does not start • Fastening nut tightened insufficiently
• Extension cable defect
• Connections on the motor or switch
defect
• Motor or switch defect
Motor runs forward or • Capacitor defect
backwards
No motor output turns • Overload by dull saw
off automatically
• Wrong saw blade
Burns on the cutting • Fastening nut tightened insufficiently
surface • Wrong saw blade
Saw band clamps • Saw band blunt
when working • Saw band resinified
• Leadership poorly adjusted
Solution
• Check the mains fuse
• See "Electrical Connection" in the operating
• Have it checked by an electrician Brake does
not bleed
• See "Electrical Connection" in the operating
manual
• Have it exchanged by an electrician
• Insert a sharpened saw blade; motor can be
turned on again
• Select saw band according to instructions
• Insert a sharpened saw blade
• Select saw band according to instructions
• Replace saw band
• Clean saw band
• Saw band guidance according to instructions
www.scheppach.com
GB | 29