AEG BSE778380T Benutzerinformation Seite 50

5.1 Initial Cleaning
Step 1
Remove all accessories and remov‐
able shelf supports from the appli‐
ance.
5.2 First connection
The display shows welcome message after the first connection.
You have to set: Language, Display brightness, Key tones, Buzzer volume, Water hardness,
Time of day.
5.3 Wireless connection
To connect the appliance you need:
• Wireless network with the Internet connection.
• Mobile device connected to the same wireless network.
Step 1 To download My AEG Kitchen app: Scan the QR code on the rating plate with the camera on your
mobile device to be redirected to AEG Homepage. The rating plate is on the front frame of the ap‐
pliance cavity. You can also download the app directly from the app store.
Step 2 Follow the app onboarding instructions.
Step 3 Turn on the appliance.
Step 4
Press:
Step 5
- slide or press to turn on: Wi-Fi.
Step 6 The appliance wireless module starts within 90 sec.
Frequency
Protocol
Max Power
Wi-Fi module
5.4 Software licences
The software in this product contains
components that are based on free and open
source software. AEG acknowledges the
contributions of the open software and
robotics communities to the development
project.
Clean the appliance and the acces‐
sories only with a microfibre cloth,
warm water and a mild detergent.
. Select: Settings / Connections.
2.4 GHz WLAN
2400 - 2483.5 MHz
IEEE 802.11b DSSS, 802.11g/n OFDM
EIRP < 20 dBm (100 mW)
NIUS-50
Step 2
movable shelf supports in the appli‐
To access the source code of these free and
open source software components whose
license conditions require publishing, and to
see their full copyright information and
applicable license terms, visit: http://
aeg.opensoftwarerepository.com (folder
NIUS).
Step 3
Place the accessories and the re‐
ance.
ENGLISH 49