cecotec FREEGO Bedienungsanleitung Seite 21

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1.
1. Power button
2. Spray button
3. Self-cleaning brush
Adapter
4.
5. Top-cover brush lock
6. Rotary brush
7. Handle
Battery
8.
9. Water tank
10. Waste-water tank
11. Floor brush
12. Support
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
appliance.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the appliance
out of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the appliance
when transporting it in the future. In case the original packaging is disposed of, make sure
all packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- FreeGo Wash Twice Spray electric mop
- Charging base
- Battery charger
- Instruction manual
40 FREEGO WASH TWICE SPRAY
3. PRODUCT INSTALLATION
Installing the handle and main body. Fig. 2
- Insert the end of the handle into the hole at the top of the appliance body, perpendicular
to the direction of the appliance and connect the connection cables as shown in Figure
2. Once you hear a click, make sure the handle is fixed in place to ensure it was correctly
installed.
- If you wish to remove the handle from the main body, press the release hole while pulling
the handle away from the appliance.
Note
During assembly, the cables must be placed into the slot and inserted. Do not apply too much
pressure to avoid damaging the cables.
Installing and removing the water tank. Fig. 3
- To remove the water tank, hold the body of the appliance with one hand, grasp the tank
with the other hand, and pull the tank out as shown in Figure 3.
- To re-install it, first place the bottom of the tank against the edge of the tank bracket and
push the tank into position as shown in Figure 3. You will hear it click into place if correctly
installed.
Installing and removing the waste-water tank. Fig. 4
To remove the waste-water tank, press the release tabs and pull the cover upwards. Once the
cover is removed, pull out the waste-water tank as shown in Figure 4. To reattach it, align the
clips at both ends of the cover, then press the assembly together until it clicks into position.
Filling up the water tank. Fig. 5
1. Remove the water tank as described in the "Installing and removing the water tank"
section.
Open the cap and pour clean water up to the marked line.
2.
3. Make sure the tank is tightly closed to avoid spillage.
4. Install the water tank as explained in the "Installing and removing the water tank" section.
You will hear it click into place if done properly.
NOTE:
- This appliance was designed to work with both distilled and tap water. Please note that the
latter may lead to limescale deposits, which in turn can clog the appliance.
- Do not exceed the marked line when filling up the tank.
Installing and removing the rotary brush. Fig. 6
To remove the rotary brush, press the right-cover lock buttons inwards and pull outwards to
ENGLISH
FREEGO WASH TWICE SPRAY 41