Updating Ubst Firmware - Fronius BSL-Tool Bedienungsanleitung

9
10
11
12
Connection of BSL-Tool with pc board SRXX
(motor regulator) - TPS 2700
Connection of BSL-Tool with pc board SRXX
(drive controller) - VR 4000 / VR 7000
Updating UBST
1
firmware
2
3
4
5
6
Danger due to incorrect operation.
This can cause serious injury and damage.
▶
After completing the update, shift the mains switch of the power source into
the - O - position
Unplug the power source from the mains
Remount the right-hand panel of the power source
Turn on the power source again. The power source is ready for welding.
Shift the mains switch of the power source into the - O - position
Unplug the power source from the mains
Remove the interface box cover
Connect flat cable from BSL-Tool to programming terminal on the pc board
Connect the RS 232 interface cable to the selected PC interface
Plug in the mains switch
WARNING!
After switching on, check that the relevant system component is not activa-
ted.
Connection of BSL-Tool with pc board SRXX
(motor regulator) - VR 1500
Connection of BSL-Tool with pc board SRXX
(drive controller) - KD 7000
19