Updating Firmware; Safety; Updating Firmware Ust - Fronius BSL-Tool Bedienungsanleitung

Updating firmware

Safety

Danger from incorrect operation and work that is not carried out properly.
This can result in serious personal injury and damage to property.
▶
▶
▶
Danger from electrical current.
This can result in serious personal injury and damage to property.
▶
▶
▶
Updating firm-
NOTE!
ware UST
Jobs created using the current version of the welding program database are ac-
cessible only if update to the same version of the welding program database.
If you update to a different version of the welding program database, you will
not be able to access existing jobs.
Example Firmware:
Official UST V3.23.22 (M0164)
1
2
3
4
5
6
7
WARNING!
All the work and functions described in this document must only be carried
out by technically trained and qualified personnel.
Read and understand this document in full.
Read and understand all safety rules and user documentation for this device
and all system components.
WARNING!
Before starting work, switch off all devices and components involved and dis-
connect them from the grid.
Secure all devices and components involved so they cannot be switched back
on.
After opening the device, use a suitable measuring instrument to check that
electrically charged components (such as capacitors) have been discharged.
Check the firmware version and the version number of the welding database
at the power supply (consult the power supply operating manual).
Shift the mains switch of the power source into the - O - position
Unplug the power source from the mains
Remove right-hand panel from power source
Connect flat cable from BSL-Tool to programming terminal of pc board
Connect the RS 232 interface cable to the selected PC interface
Plug in the mains switch
Database number (MIG/MAG) of the
database welding program
Version of Firmware
UST Firmware
17