Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MI 120 switch SW1 settings
Probe triggered high
(pin 4)
SW1
Probe triggered low
(pin 4)
NOTE: Automatic START selection causes
the system to send a START signal once a
second and does not require a CNC
machine control input.
Enabled low
Low battery high
(pin 5)
Normal
position
Invert
position
Enabled high
Low battery low
(pin 5)
Machine START requires a
10 V - 30 V, 2 mA positive edge
on pin 3, to cause the system
to send a START signal.
MI 120 switch SW1 settings
– factory settings shown
Enable
(pin 6)
Error and
(pin 6)
low battery
Machine START
No function
(pin 3)
6
F
Automatic
START
Machine and
automatic START
require the probe to
be in time-out mode.
1-11
Werbung
