Mount wirefeeder
fixture and gas-
cylinder holder
(8)
Fig.20 Mount the wirefeeder fixture
Caution! Danger due to gas-cylinder tipping over.
-
Use safety-strap
-
Fix safety-strap at the same height as the top part of the gas-cylinder
-
Never fix safety-strap as far up as the neck of the gas-cylinder
1.
Slot the wirefeeder fixture (9) into the
(9)
power source and lay it down flat
2.
Using the four screws, tightly screw
the wirefeeder fixture (9) onto the
extension plate of the gas-cylinder
holder (8)
Caution! If devices were to fall off,
this would be dangerous. Make
sure that all screw connections are
mounted firmly.
13