Werbung
Verfügbare Sprachen
Verfügbare Sprachen
'Notes on Connections'
On the connection to VIDEO 1 of the SB-V66S
Be sure to connect the video unit with the S VIDEO jack to
the VIDEO 1 jack of the SB-V66S. Also connect the cables
to both the VIDEO INPUT and OUTPUT jacks.
On the connection of a TV (monitor
© Be sure to use a TV (monitor) with S VIDEO jacks (two or
more sets of input jacks in total). In this case, connect the
cables to the TV's (monitor's) VIDEO INPUT jack, as well
as to the TV's (monitor's)
S VIDEO jack.
© If the TV (monitor) is equipped with 'two sets of input
jacks, the S VIDEO and VIDEO output from the SB-V66S
should be connected separately to each set of input jacks
on a TV (monitor) (e.g. to VIDEO 1 and VIDEO 2).
© If the TV (monitor) is equipped with an S VIDEO/VIDEO
selector, set the selector according to the type of signal to
be used (S VIDEO or VIDEO).
On the connections to VIDEO 2, 3, and 4
© For video units with the S VIDEO jacks, use the S VIDEO
and audio jacks only.
© If the video unit connected to VIDEO 2 is equipped with
an S VIDEO/VIDEO selector, set it to S VIDEO.
'Notes on Monitoring Pictures from
'the Video Units
© The input selector of the TV (monitor) should be set to the
appropriate position as follows:
—When you monitor the picture from the video unit with
S VIDEO jack, set the input selector of the TV (monitor)
to the position corresponding to the input where the
connection is made with S VIDEO signal (i.e. VIDEO 1
in the Example 2).
—When you monitor the picture from the video unit
without a S VIDEO jack, set the input selector of the
TV (monitor) to the position corresponding to the input
where the connection is made with normal VIDEO
signal (i.e. VIDEO 2 in the Example 2).
¢ Connections shown in Example 2 allow you to monitor the
picture from the video unit 1 regardless of the TV's
(monitor's) input selector setting. When the selector is set
to VIDEO 1, the pictures through the S VIDEO jack can
be monitored, and when it is set to VIDEO 2, the pictures
through the VIDEO jack can be monitored.
Notes on Editing
Copying from the video unit connected to VIDEO 2, 3, or
4 to the one connected to VIDEO 1 — when one of the
COPY
,
» and
buttons
has been
depressed
© If the video unit connected to VIDEO 1 is equipped with
an S VIDEO/VIDEO selector, set it to the appropriate
position as follows:
Playing-side unit
S VIDEO/VIDEO selector
om the video unit 1 setting
Equipped with S VIDEO jack! S VIDEO
Not equipped with S VIDEO | VIDEO
jack
¢ If the unit connected to VIDEO 1 is not equipped with
an S VIDEO/VIDEO selector and when copying is to be
made from the video unit which is not equipped with the
S VIDEO jack, remove the cable from the S VIDEO input
jack of the unit connected to VIDEO 1. Otherwise, copying
is not made because the S VIDEO input jack is
automatically selected when both the S VIDEO and
VIDEO inputs are connected. When copying from the
video unit equipped with the S VIDEO jack, it is not
necessary to remove the cable.
Connection on the video
unit 1 (recording-side unit)
Equipped with S VIDEO jack| Leave the cables connected
on both the S VIDEO and
Playing-side unit
VIDEO jacks.
Remove the cable from the
jack
S VIDEO input jack.
Not equipped with S VIDEO
Copying from the video unit connected to VIDEO 1 to
the one connected to VIDEO 2 — when the COPY
[1-2] button is depressed
Copying will be made through the VIDEO jacks.
For details on the operations of this unit, see page 10.
13
Werbung
