Controlling The Security System; Operating The Control Panel; System Activation (Normal Group); Partial System Activation (Home Group) - LAMAX TECH Shield Handbuch

Controlling the Security System

The security system can be controlled via SMS, via the Android or iOS app or the control panel.
IMPORTANT: Always enter account names, sensors, RFID tags and remote controls without diacri-
tical marks.Always enter telephone numbers with the international dialling code starting with two
zeros instead of +.
Example: 0044 123 456 789

Operating the Control Panel

System Activation (Normal group)

Press the "LOCK" button.All sensors are activated.

Partial System Activation (Home group)

Press the "HOME" button.The sensors assigned to the Home group are not activated when the control
panel is set to Home Mode.

Disarming the System on the Control Panel

The system can be disarmed on the control panel by entering the four-digit security passcode (default
1234) and pressing the "UNLOCK" button. One beep indicates that the system is disarmed. Three beeps
indicates that the security code has been entered wrongly.

Disarming the System Using an RFID Tag

Hold the RFID tag to the RFID reader (blue circle on the left of the control panel). Successful deactiva-
tion is confirmed by a beep.
IMPORTANT: In order to disarm the system using the RFID tag, the control panel must be connected
to the mains. RFID tags can only be used to disarm the system, anot to arm it.

Recording and Playing Back Voice Memos

Press the "RECORD" button for 3 seconds and record a voice message. Maximum length of a voice
message is 10 seconds. If the message is less than 10 seconds, press the "RECORD" button again when
you have completed the message. Voice message can be played back by holding an RFID tag up to
the reader.

Speed Dial

Press the "CALL" button to immediately call the security company on a preset number. Press "CALL"
again to end the call.

Making a Call

It is possible to directly call any phone using the security system. Just select the phone number on the
control panel and press "CALL". The call uses the microphone and speaker built into the control panel.
Press "CALL" again to end the call.

Recording the Emergency Call Message

When the control panel alarm is triggered it calls all emergency telephone numbers and plays a mess-
age. To record the message press the "HOME" button, then enter the security passcode (default 1234),
press "HOME" again and finally press "RECORD". You have 10 seconds to record the message.

Restoring Factory Settings

Restoring factory settings, or doing a "hard reset" is performed whenever the SIM card is changed. This
can also be done manually by pressing the tamper switch at the back of the control panel five times
in three seconds.
3