Rfid Tag; Troubleshooting - LAMAX TECH Shield Handbuch

Material
Operating Temperature
Operating Humidity
Dimensions

RFID Tag

Circuit
Radio Frequency
Dimensions
Electrical products should not be disposed of with other waste. According to European Directive
2002/96/EC on electrical waste, electronic equipment and its components must be individually han-
ded in at collection points.
NOTE: If you replace the battery in the device with an unapproved type, you risk damage or fire.
Use only batteries approved according to the technical parameters.

Troubleshooting

If the Shield by LAMAX Tech is not functioning properly, try the following solutions.
Control panel will not turn on.
- Make sure it is properly connected to the power supply.
- Make sure the power is on.
Remote control does not work.
- Make sure the LED lights up when you press the unlock button.
- Check that the remote is properly paired with the control panel.
- Ensure that the remote control and control panel in range.
Magnetic sensor does not work.
- Check that the LED lights up when the door/window is opened.
- Ensure that the remote control and control panel are in range.
- Make sure the security system is armed.
- Make sure the distance between the sensor and magnet is less than one centimetre.
PIR motion sensor is triggered but control panel alarm does not sound.
- Press the test button on the sensor when the security system is armed. If the control panel alarm does
not sound, re-pair the sensor and control panel.
- Ensure that the sensor band control panel are in range.
- Make sure the sensor is not in standby mode.
- Make sure the battery is not dead.
Control panel does not respond to SMS commands.
- Check the SIM card is inserted correctly.
- Ensure the SIM card was inserted before the system was turned on.
- Check that the SIM card is connected to the GSM standard network.
- Ensure the SIM card has active credit.
- Make sure the SIM card has SMS and calling enabled.
When alarm is triggered, you do not receive any SMS.
- Ensure that the emergency number has been stored in the control panel memory.
- Do not disarm the alarm immediately after it is triggered, otherwise the call is interrupted.
- Make sure the SIM card has active credit.
Security system triggers the alarm, but there is no sound.
- Make sure the sound is not muted on the control panel. Reset the alarm siren via SMS or the app.
Magnetic sensor battery life.
- Magnet is powered by a single AA battery which should last approximately 8-12 months. This de-
pends on how often the doors/windows are opened and closed.
ABS + PC plastic
-10 to +50° C
Up to 80% (non-condensing)
58 x 31 x 9.5 mm
EM4100 CMOS
125 KHz
30 x 30 x 6 mm
18