Deleting Sensors, Rfid Tags And Remote Controls From The System; Deleting Sensors From The System; Deleting Rfid Tags From The System; Deleting Remote Controls From The System - LAMAX TECH Shield Handbuch

Deleting Sensors, RFID Tags and Remote Controls from the System

All accessories (sensors, RFID tags and remote controls) can be deleted from the system by pressing the
tamper switch 3 times in 3 seconds. The control panel emits two beeps when the accessory is cleared.

Deleting Sensors from the System

The numeric code for deleting sensors from the system is "21". By sending the code to the control panel
SIM phone number the sensors are deleted from the system. Upon activation, the control panel sends
a confirmation SMS.

Deleting RFID Tags from the System

The numeric code for deleting RFID tags from the system is "22". By sending the code to the control
panel SIM phone number the RFID tags are deleted from the system. Upon activation, the control
panel sends a confirmation SMS.

Deleting Remote Controls from the System

The numeric code for deleting remote controls from the system is "21". By sending the code to the
control panel SIM phone number the remote controls are deleted from the system. Upon activation,
the control panel sends a confirmation SMS.

Restoring the System Factory Settings

The numeric code to restore factory settings of the system is "0000". By sending this code to the control
panel SIM card phone number, the system is reset to its original settings. Upon activation, the control
panel sends a confirmation SMS.

Other SMS Notifications

These notifications are sent to the first stored telephone number for SMS alerts. The alerts warn of:
- Low battery in the control panel or sensors
- Break in the power supply to the control panel
- If the tamper switch on the control panel or sensors has been activated (SMS is sent to all phone
numbers).

Arming and Disarming with a Free Phone Call

The security system can be armed by calling the control panel SIM card number. When it starts ringing,
hang up. The control panel will then call you back. The alarm is then armed.
The security system can be disarmed by calling the control panel SIM card number. Do not hang up,
wait and the system will automatically disarm. The control panel will not call you back.
IMPORTANT: When arming and disarming, voicemail must be turned off on the control panel SIM
card.
10