Internal Layout; Infrared Sensors; Tamper Switch; Led - LAMAX TECH Shield Handbuch

Internal Layout

Infrared Sensor
Carefully remove the cover from the back of the sensor.

Infrared Sensors

Infrared sensors detect movement. Therefore always keep them clean. Do not touch the sensor.

Tamper Switch

If the PIR motion sensor cover is opened, the tamper switch sends a signal to the control panel.

LED

The LED on the front of PIR motion sensor can be switched on or off by moving the jumper.
Back of the PIR Motion Sensor

Test Mode

Press the test button and when auto-testing is complete the PIR motion sensors sends a signal to the
control panel.

Power Saving Mode

PIR sensor automatically goes into power saving mode if movement is detected twice in three minutes.
If movement is detected within the next three minutes it goes back into working mode. During those
three minutes the sensor cannot be activated and does not send a signal to the control panel. If the
sensor detects movement within the following three minutes, it goes into power saving mode for a
further three minutes.

Connecting a PIR Motion Sensor

IMPORTANT: When pairing a sensor, make sure the other sensors are not detecting movement.
Either cover these sensors or temporarily move them to a room where there will be no movement.
The sensors that are included are paired with the control panel by default.
To pair a PIR motion sensor, enter the control panel passcode and press the "RECORD" button. The bu-
tton will light up. Press the test button on the back of the sensor twice or make a movement in front of
the motion sensor. When you hear the beep, the PIR sensor is paired. If the control panel beeps twice,
it means the sensor has already been paired.

Installing a PIR Motion Sensor

Do not install sensor directly on a window, close to air conditioning, heating, refrigerator, oven, in
direct sunlight or in places where the temperature often varies. Avoid installing two sensors opposite
each other or covering the same range.
LED
13
Infrared Sensor
Tamper Switch
Mode Settings