Testing A Pir Sensor; Magnetic Sensor; Product Layout; Led - LAMAX TECH Shield Handbuch

NOTE: The ideal height to install the sensor is 2.2 metres.
Fix the sensor mount in place with the screws included. Insert the sensor into the mount. Position the
sensor to cover the desired area. Test the functioning of the sensor by putting it into test mode.
IMPORTANT: Do not move the sensor up or down when using the pet recognition function.

Testing a PIR Sensor

1. Once the motion sensor is installed and active, proceed to testing. Press the test button once and
navigate around the room from left to right and right to left.
2. When the sensor detects motion, the LED blinks twice.
3. Adjust the angle if necessary and repeat the procedure.

Magnetic Sensor

Product Layout

Sensor
Magnet

LED

Single blink: opening of door/window detected
Blink every 3 seconds: low battery warning
NOTE: If the battery is running low, the device will send an SMS alert.

Internal Layout

Tamper Switch
Mode Settings
Tamper Switch
If the magnetic sensor cover is opened, the tamper switch sends a signal to the control panel.
14