Leaving A Voice Memo; Control The System When Emergency Call Made - LAMAX TECH Shield Handbuch

??
- Store alarm phone No. - 5
- Store alarm SMS No. - 6
- Store SMS No. for RFID tags - 7
- Store speed dial phone No. - 8
???
- Zone name – 91-99
- RFS tags SMS notice - 10
- Entry and exit delay time - 11
- Siren volume and ringing time - 12
- Disarm password - 13
- Single zone delay time - 14
Changing the Language
Each language has its own four-digit code. Set the language by sending an SMS with the four-digit
code to the control panel SIM card number. Upon receipt the language change is made and the control
panel sends back a confirmation SMS.
NOTE: The language can also be set using the app.
Disarming the Alarm via SMS
By sending a text message with one question mark, a list of commands with numeric codes are dis-
played. Disarming the alarm is number "0". To disarm, send an SMS with this code to the control panel
SIM card number. When successfully disarmed, the control panel sends a confirmation SMS.
Arming the Alarm via SMS
The alarm can be armed in the same way as disarming. The code to activate the system is "1". To arm the
system send this code via SMS to the control panel SIM card number. When armed, the control panel
sends a confirmation SMS.
Partial Alarm Activation via SMS (Home Mode)
Putting the alarm in home/stay mode works the same way as fully arming the system. The activation
code is "2". Send this code via SMS to the control panel SIM card number to put the system into home
mode. Upon activation, the control panel sends a confirmation SMS.
Two-Way Talk
To activate a two-way call send the code "3" to the control panel SIM card number. The system calls
back immediately to your phone and you can speak to someone through the control panel.

Leaving a Voice Memo

To leave a message send the code "4" to the control panel SIM card phone number. The system imme-
diately calls back to your phone number. Answer the phone and leave a message of no longer than 10
seconds. The message can be played back by holding an RFID tag to the reader on the control panel.

Control the System when Emergency Call Made

When the alarm is triggered, the control panel calls the preset numbers. The following commands can
be made by pressing the corresponding number code.
Command
Disarm
Arm
Turn Off Siren
Turn On Siren
Two-Way Talk
Play Emergency Message
Code Number
0
1
6
9
*
#
7