Changing Sensor Names; Naming An Rfid Tag; Changing The Rfid Tag Name; Changing The Exit And Entry Delay Time - LAMAX TECH Shield Handbuch

Changing Sensor Names

Each sensor can be named individually. The first nine sensors (1-9) can be named using up to a ma-
ximum 30 characters. The names of sensors 10 and above can not be renamed. To check the sensor
name, send the code "91" - "99" to the control panel SIM card number.
Copy the received SMS text message and paste it into a new message. Then fill in the sensor name and
send it back to the control panel SIM card number.

Naming an RFID Tag

RFID tags can be named. If the owner of the tag disarms the alarm, the system sends a text message
to the preset phone number
IMPORTANT: Sending SMS only works if the RFID tag is named and the administrator phone number
to which it is sent is set.

Changing the RFID Tag Name

Each RFID tag can be named. To find out the name of the tag, send the code number "10" to the control
panel SIM card number.
Copy the received SMS text message and paste it into a new message. Then fill in the tag names and
send the SMS back to the control panel SIM card number. The text message can contain several names.
Example:
Information about the names of individual chips might look like this:
Change RFID tag names:
1. Dad
2. Mum
3. Tomas
4. Sarah

Changing the Exit and Entry Delay Time

With this security system it is possible to set up a time delay when arming or disarming the alarm.
When set up, the control panel beeps every second and its frequency increases in the last 15 seconds.
To determine the length of the time delay, send the code number "11" to the control panel SIM card
number.
Copy the received SMS text message and paste it into a new message. Then set the length of the time
delay and send it back to the control panel SIM card number. Maximum time delay is 300 seconds.

Setting the Siren Volume and Ring Time

To determine the length and volume of the alarm, send the code number „12" to the control panel SIM
card number.
Copy the received SMS text message and paste it into a new message. Fill in the alarm length and
volume and send it back to the control panel SIM card number.

Changing the Disarm Password

To determine the deactivation passcode, send code "13" to the control panel SIM card number.
Copy the received SMS text message and paste it into a new message. Fill in the new deactivation
password and send it back to the control panel SIM card number.

Setting Single Zone Delay Time

With this security system it is possible to set the entry and exit delay time for single zones. To deter-
mine the length of the delay time for each zone, sent the code number "14" to the control panel SIM
card number.
Copy the received SMS text message and paste it into a new message. Then set the length of the delay
time and send it back to the control panel SIM card number. The maximum length of the time delay
is 300 seconds.
9