Scheppach HS410 Original Bedienungsanleitung Seite 31

14. Storage
• Store the device and its accessories in a dark, dry
and frost-proof place that is inaccessible to children.
• The optimum storage temperature is between 5 and
30˚C.
• Cover the electrical tool in order to protect it from
dust and moisture.
• Store the operating manual with the electrical tool.
15. Maintenance
Attention!
Pull out the power plug before carrying out any mainte-
nance work on the equipment.
Connections and repairs
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Change of saw blades (Fig. 22 - 27)
1. Unplug the unit.
2. Wait until the blade stops rotating and the motor
has cooled down.
3. Bring the jack into the transport position and lock
the saw in this position with the locking lever.
4. Remove the guard (17).
5. Loosen the nuts (I2) on the guide (17a).
6. Now push the guide (17a) out of the threaded pin.
7. Loosen the chain (12).
8. Remove the spring split pin (17a) from the recoil
spring (11).
9. Loosen the locking lever and grasp the jack firmly
so that it does not fall down and the recoil spring
cannot jump out of the unit in an uncontrolled fash-
ion.
10. Tip the jack carefully back and place it on the
ground. (fig. 24)
11. Remove the outer saw blade guard (14) (fig. 25)
12. Loosen the hex nut with the installation tool (25)
provided (fig. 26)
13. Remove the outer flange (22)
14. Carefully remove the saw blade. Wear protective
gloves for this part of the work. (Attention: there is
danger of injury, so please take caution!)
15. Before replacing the saw flange, clean the flange
with a cloth or soft brush.
16. Replace the saw blade and flange and tighten the
hex nut.
17. Reassemble the device in reverse order.
18. Test the functionality of the rocker.
ATTENTION ! Observe the correct direction of rotation
when inserting the saw blade.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Motor data - type plate
• Machine data - type plate
Service information
Please note that the following parts of this product
are subject to normal or natural wear and that the fol-
lowing parts are therefore also required for use as
consumables.
Wear parts*: sawblade, rocker inlet
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
16. Disposal and recycling
The equipment is supplied in packaging to
prevent it from being damaged in transit. The
raw materials in this packaging can be reused
or recycled. The equipment and its accesso-
ries are made of various types of material,
such as metal and plastic. Defective compo-
nents must be disposed of as special waste. Ask your
dealer or your local council.
www.scheppach.com GB | 31