Werbung
ENGLISH
Jumper Pin Setting 7
res
ot
N When you insert a jumper pin, "ON" is set.
El © No jumper pin can be set.
Factory use only.
® SCSI ID
@ TERMINATOR
Terminator Setting
(Factory Default: ON)
À terminator refers to a terminating resistance. The
terminators must be set properly when SCSI units (in-
cluding the drive) have been connected to the person-
al computer.
E When the drive is connected at the terminating
end:
(for example, illustration EI E © or © on page 20)
Be sure to set "ON". E]
m When
the
drive
is connected
between
SCSI
units:
(for example, illustration El @-® on page 20)
Be sure to set "OFF".
SCSI ID Setting EI
(Factory Default: 4)
The SCSI ID is a number identifying each SCSI unit.
These IDs must be unique for each unit on the SCSI
bus.
Generally, the SCSI IDs are set as follows:
Hard Disk Drive: 0
eCD-ROM Drive: 3
eSCSI Host Adapter: 7
Check the SCSI ID (refer to devices instruction manu-
al) for each device connected on the SCSI bus.
Set the PD/CD-ROM drive's ID so as not to duplicate
any other device's ID.
LUN Setting
(Factory Default: OFF)
The LUN
(Logical Unit Number)
is a function that
causes
the personal
computer
to differentiate
be-
tween PO cartridges, CDs and CD-ROMs.
When the unit is connected to an IBM PC/AT or com-
patible computer, set the factory default "OFF".
22
Rear panel of this drive
Rückwand dieses Laufwerks
Panneau arriére du lecteur
Jumper pin
Uberbrückungsstift
Broche de connexion
"OFF"
No jumper pin
Kein Überbrückungsstift
Pas de broche de
connexion
torse
HOARE
E HS HARES
AREA
RH DO
RE
EP
HERO HOR
HEROES
"0"
Werbung
