14.3
Electrical connection
Dangerous electrical voltage!
Risk of injury due to dangerous electrical voltage!
The machine may only be connected to the mains supply and the associated
checks carried out by a qualified electrician or under the instruction and super-
vision of a qualified electrician!
Check, whether the neutral connection (if existing) and the protective grounding function
•
properly.
Check, whether the supply voltage and the frequency correspond to the specifications of the
•
machine.
Deviation of the supply voltage and frequency!
A deviation from the value of the supply voltage of ±5 % is permissible. A short-circuit
fuse must be provided in the power supply system of the machine!
Use a supply cable that fulfils the electrical requirements (e.g. H07RN, H05RN) and take the
•
required cross-section of the supply cable from a current carrying capacity table. Pay atten-
tion to the measures for protection against mechanical damage.
•
Make sure that the power supply is protected by a residual current circuit breaker.
•
Connect the machine only to a properly grounded outlet.
When using an extension cable, make sure that the dimension matches the connected load
•
of the machine. The connection power can be found in the technical data, the correlation of
cable cross-section and cable lengths can be found in the technical literature or obtain infor-
mation from a specialist electrician.
A damaged cable must be replaced immediately.
•
HOLZMANN MASCHINEN GmbH
Attach the quick release chuck to the spindle.
•
•
Lower the spindle with the spindle travel handle until
the quick release chuck hits the wood on the drilling
table.
Apply pressure to the quick release chuck with the
•
spindle travel handle so that the quick release chuck
is fixed in the spindle.
6. Adjust the height of the spindle protection cover
•
Adjust the height of the spindle protection cover. To
do this, loosen the screw (1).
NOTE:
too low (a).
The chuck should be well concealed by the spindle protec-
tion cover (b).
After adjustment, retighten the screw (1).
•
WAR N I N G
N O TE
www.holzmann-maschinen.at
Take care that the spindle protection cover is not set
ASSEMBLY
33
SB13B16VN_230V