Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Working position
Preparation of the surfaces
Before putting the machine into operation, carefully remove the corrosion protection or grease
residues from the bare metal parts. This can be done with the usual solvents. Under no
circumstances should you use nitro thinners or other cleaning agents, as these can attack the
machine´s finish.
The use of paint thinners, petro, aggressive chemicals or scouring agents will damage
the surfaces!
Therefore: Use only mild cleaning agents!
14.2
Assemble
The machine comes pre-assembled, it is necessary to assemble the components dismantled for
transport according to the following instructions and to make the electrical connection. The assem-
bly is described on the example of SB203VH_230V.
HOLZMANN MASCHINEN GmbH
Anchoring to the workplace
Due to the height of the own weight, fixing the machine on
a workbench, for example, is a prerequisite for low-vibra-
tion work. This prevents movement of the machine during
operation and possible damage or injury.
The base of the machine is equipped with six bore-
•
holes (1), by which the machine is firmly anchored to
the surface of the chosen workplace.
The required depth depends on the hardness / con-
•
sistency of the surface at the workplace - the less hard
the surface is, the greater the anchoring depth re-
quired.
Use suitable screws.
•
Ensure that the entire working area and danger zone
•
is visible from the working position.
•
The operation panel and operating elements of the
machine must always be accessible.
•
Avoid abnormal body posture: Keep a safe posture and
maintain your balance at all times.
N O TE
N O TE
The machine and machine components are heavy!
2 persons are required to assemble the machine.
www.holzmann-maschinen.at
ASSEMBLY
31
SB13B16VN_230V
Werbung
