Herunterladen Diese Seite drucken

ESX VISION VE1300.11SP Benutzerhandbuch Seite 27

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

CONNECTIONS & FUNCTIONAL DESCRIPTION
SPEAKER OUTPUT (MINIMUM IMPEDANCE 3 - 8 OHMS, NOT BRIDGEABLE)
14
Slot for the included wire harness with 18-pin connector. Connect the speaker wires from the wire
harness to the corresponding connector wires on the speakers. Use sufficiently dimensioned speaker
cables for this.
15
STATUS LED
• If the POWER LED lights up, the device is ready for operation.
• If the ERROR LED lights up, there is a malfunction.
In this case, press the reset button (see section 7)
• If the BT LED lights up, a Bluetooth connection has been established.
16
SPEAKER OUTPUT (CH10 / CH11 - MINIMUM IMPEDANCE 2 - 8 OHMS, NOT BRIDGEABLE)
Slot for the enclosed wire harness with 10-pin connector. Connect the speaker wires from the wiring
harness to the corresponding connector wires on the subwoofer. Use sufficiently dimensioned speaker
cables for this.
THE FOLLOWING SWITCHES AND CONTROLLERS ARE LOCATED ON THE REAR UNDER THE COVER
WHICH YOU CAN REATTACH AFTER SETUP.
17
AUTO TURN-ON
17
If your head unit does not have a turn-on signal (REM), you can use the automatic turn-on function of
the device. This works in two ways, which can be set at the AUTO TURN-ON switch:
VOX: Select this method when using the RCA jacks at LOW LEVEL INPUT. The device then detects
a voltage increase in the incoming audio signal when switching on the head unit via the attached RCA
cable and then switches on the device.
DC: This method only works if you use the device's high level inputs at HIGH LEVEL INPUT. The
device then detects a voltage rise to 6 volts when the head unit is turned on by a so-called "DC offset"
and then turns on the device.
OFF: Select this position, if you have connected a turn-on signal at the REM IN terminal.
NOTE
PRIORITY INPUT MODE
The device detects the arrival of a digital input signal (e.g. via OPTICAL IN, COAXIAL IN or Bluetooth
This input signal is then given priority over the analog input signals as long as the signal source is active.
You can change this setting via software or app.
ENGLISH
).
®
27

Werbung

loading