Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
ELECTRICAL CONNECTIONS
BEFORE CONNECTING
For the professional installation of a sound system, car audio retail stores offers appropriate wire kits. Ensure
a sufficient cross section of at least 16 mm
you purchase your wiring kit. Clean and remove rust-streaked and oxidized areas on the contact points of the
battery and the ground connection. Make sure that all screws are fixed tight after the installation, because
loose connections cause malfunctions, insufficient power supply or interferences. Do not set in the fuse until
the installation is accomplished.
4
POWER INPUT +12V (recommended)
1
Connect the 12 volt connection of the amplifier to the 12 volt positive pole of the vehicle battery using
the cable provided with a cross-section of at least 16 mm
POWER INPUT GND (recommended)
2
Connect the amplifier's GND connection to a suitable ground point on the vehicle chassis. The ground
wire should be as short as possible and attached to a bare metal point on the vehicle chassis. Ensure
that this point has a secure electrical connection to the vehicle battery negative terminal. Also check the
ground wire from the battery to the body and strengthen it if necessary. Use a cable with a cross-section
of at least 16 mm
LIMITED POWER INPUT
3
If, for installation-related reasons, you use the enclosed 10-pin wire harness to supply the amplifier with
power, the output power of the amplifier will be reduced by around 20%.
Alternatively, the three power inputs can also be used as an additional power supply to the regular POW-
ER INPUT. Each of the three pairs of pins can be loaded with a maximum of 25 A.
24
, the suitable fuse rating and the conductivity of the cables when
2
for the connection.
2
FAHRZEUG-
BATTERIE
< 30 cm >
.
2
3
1
2
5
100 A
6
Werbung
