Philips HR2345/19 Benutzerhandbuch Seite 13

1
Turn the control knob to "OFF" and disconnect the plug from the power outlet.
(Fig. 35)
2 Pull the lid to unlock it and then remove the lid from the mixing chamber. (Fig. 3)
3 Slide the mixing chamber off the main unit. (Fig. 4)
4 Turn the shaping disc holder counterclockwise to remove it from the mixing chamber
outlet. (Fig. 5)
5 Put your finger in the mixing chamber and push the squeezing tube outwards to slide
it out of the mixing chamber outlet (Fig. 6). Detach the shaping disc, and then pull the
squeezing bar out of the squeezing tube (Fig. 7).
6 Take the mixing paddle out of the mixing chamber. (Fig. 8)
7 Clean the shaping disc with the supplied cleaning tool to remove the dough residues.
After that, you can clean it with water. (Fig. 36&37)
8 Use the supplied cleaning brush to clean all detachable parts with dishwashing liquid
and warm water or clean in the dishwasher. Wipe all parts dry.
Tip: Use the pointing end of the cleaning brush to clean the inner bottom of the
squeezing tube. (Fig. 38)
9 Clean all detachable parts with dishwashing liquid and warm water or clean in the
dishwasher. After that, wipe all parts dry.
10 Use a dry cloth to clean the main unit, control knob, and the exterior of the Pasta
maker. (Fig. 39)
Note: After cleaning, make sure all parts and the shaping disc air dry thoroughly
before storing. Assemble the Pasta maker back for next use.
Storage
1 Wind the power cord around the cord storage wrap. (Fig. 40)
2 Dry the shaping discs and store them in the storage box.
Note: The small groove in the storage box is designed for the cleaning tool of the
angel hair shaping disc, which is not included in this Pasta maker. It will be launched
and sold separately. (Fig. 41)
3 Store the Pasta maker in a dry, well ventilated place after use.
ENGLISH
15