Internorm I-tec Programmieranleitung Seite 50

7. b) Calibrate top end position of shading
This function is needed if the shading in normal operation does not go
completely up to the top position any longer.
1. Select the 'Menu' function
2. press and hold = confirm selection
3. press briefly = selection of shading whose top end position
should be calibrated. Shading needs to be programmed
before.
= channel 1
© £ £ £
= channel 2
£ © £ £
4. Press button and hold
Blind moves to the top
IMPORTANT: Wait till blind has moved to top end position
and stops, before briefly pressing
5. press briefly = function completed.
This brings you back to 1. Function selection menu
Further possibilities:
1) press and hold = repeat process
2) press briefly = to select an option from the 'Menu'
6.
3) press and hold or no operation for 25 sec. =
finish installation mode
50
= channel 3
£ £ © £
= channel 4
£ £ £ ©
to confirm
£ © © £
© £ £ £
© £ £ £
£ © © £