4. Delete radio transmittor from shading
1.
Select the 'Menu' function
press and hold = confirm selection
2.
Scan starts
3.
When blind is located, the 1
When no blind has been located, the program returns to
1. Function Selection Menu
4.
press briefly = enable to click through all located blinds
and select the required one
Blinds are sorted according to their signal strength:
= blind 1
© £ £ £
= blind 2
£ © £ £
= blind 3
£ £ © £
Check for activated blind with
5.
press and hold = confirm selection
6.
press briefly = select blind which is to be deleted
a)
£ © © £
was used to carry out action
b)
© £ £ ©
programmed for this shading
press and hold = confirm selection
7.
Delete process starts
8.
Possible feed back:
= Ok
© © © ©
LED flashes
No communication/error, repeat process
press briefly = confirm feed back.
9.
This brings you back to 1. Function Selection menu
Further possibilities:
1)
press and hold = repeat process
10.
2)
press briefly = to select an option from the 'Menu'
3)
press and hold or no operation for 25 sec. =
finish installation mode
LED flashes
st
£ £ £ ©
© £ £ ©
£ © £ ©
= Delete blind on radio transmittor which
= delete any radio transmittors which are
/
ª £ £ £
£ £ £ ª
© £ £ £
£ © © ©
= blind 4
= blind 5
= blind 6 ...
or
!
(from 1 to 4) =
© £ © ©
ª ª ª ª
.
© £ £ £
© £ £ £
© £ £ £
£ © © £
© £ £ ©
ª ª ª ª
© © © ©
© £ © ©
GB
45