Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATING MODE
The shading is operated in operating mode. All driving or turning movements take
place here. Automatic functions can be started or paused in operating mode.
Also the individual fixed position can be controlled.
Channel selection
press briefly
press briefly
press and hold
Movement of blind
press briefly up
press briefly down
or
press briefly
Adjusting slats
or
press and hold
Individual fixed position
press at the same time
A fixed positon is preallocated at the factory: shading is down, with blinds set to
50 % view.
Start automatic funtions
1.
Press both buttons and hold = confirm selection
2.
Automatic functions activated
Pause automatic functions
1.
Press both buttons and hold = confirm selection
Automatic functions deactivated
2.
There are no factory-made defaults for automatic functions. These need to be
activated in installation mode.
Start and stop heat protection mode
If the automatic function of heat protection is activated, the function is
interrupted until the following day by operating buttons
Displays the active channel
Switch channel
Select all channels directly
or
Blind moves to the top
Blind moves to the bottom
Blind stops
or
slats are turned in steps, as long as the
button is kept pressed
shading goes to individual programmed
position
¦ ¦ ¦ ¦
© © © ©
§ § § §
© £ £ £
or
.
GB
X
41
Werbung
