Beko BBIM13400XMPSEW Bedienungsanleitung Seite 39

• Some detergents or cleaning agents
cause damage to the surface. Unsuitable
cleaning agents are: bleach, cleaning
products containing ammonia, acid or
chloride, steam cleaning products, de-
scaling agents, stain and rust removers,
abrasive cleaning products (cream
cleaners, scouring powder, scouring
cream, abrasive and scratching scrub-
ber, wire, sponges, cleaning cloths con-
taining dirt and detergent residues).
• No special cleaning material is needed in
the cleaning made after each use. Clean
the appliance using dishwashing deter-
gent, warm water and a soft cloth or
sponge and dry it with a dry cloth.
• Be sure to completely wipe off any re-
maining liquid after cleaning and imme-
diately clean any food splashing around
during cooking.
• Do not wash any component of your ap-
pliance in a dishwasher unless otherwise
stated in the user's manual.
Inox - stainless surfaces
• Do not use acid or chlorine-containing
cleaning agents to clean stainless-inox
surfaces and handles.
• Stainless-inox surface may change col-
our in time. This is normal. After each
operation, clean with a detergent suit-
able for the stainless or inox surface.
• Clean with a soft soapy cloth and liquid
(non-scratching) detergent suitable for
inox surfaces, taking care to wipe in one
direction.
• Remove lime, oil, starch, milk and protein
stains on the glass and inox surfaces
immediately without waiting. Stains may
rust under long periods of time.
• Cleaners sprayed/applied to the surface
should be cleaned immediately. Abrasive
cleaners left on the surface cause the
surface to turn white.
Enamelled surfaces
• After each use, clean the enamel sur-
faces using dishwashing detergent,
warm water and a soft cloth or sponge
and dry them with a dry cloth.
• For difficult stains, an oven and grill
cleaner recommended on the website of
your product brand and a non-scratch-
ing scouring pad can be used. Do not
use an external oven cleaner.
• The oven must cool down before clean-
ing the cooking area. Cleaning on hot
surfaces shall create both fire hazard
and damage the enamel surface.
Catalytic surfaces
• The side walls in the cooking area can
only be covered with enamel or catalytic
walls. It varies by model.
• The catalytic walls have a light matte
and porous surface. The catalytic walls
of the oven should not be cleaned.
• Catalytic surfaces absorb oil thanks to
its porous structure and start to shine
when the surface is saturated with oil, in
this case it is recommended to replace
the parts.
Glass surfaces
• When cleaning glass surfaces, do not
use hard metal scrapers and abrasive
cleaning materials. They can damage the
glass surface.
• Clean the appliance using dishwashing
detergent, warm water and a microfiber
cloth specific for glass surfaces and dry
it with a dry microfiber cloth.
• If there is residual detergent after clean-
ing, wipe it with cold water and dry with
a clean and dry microfiber cloth. Resid-
ual detergent may damage the glass
surface next time.
• Under no circumstances should the
dried-up residue on the glass surface be
cleaned off with serrated knives, wire
wool or similar scratching tools.
• You can remove the calcium stains (yel-
low stains) on the glass surface with the
commercially available descaling agent,
with a descaling agent such as vinegar
or lemon juice.
• If the surface is heavily soiled, apply the
cleaning agent on the stain with a
sponge and wait a long time for it to
work properly. Then clean the glass sur-
face with a wet cloth.
EN / 39
EN
DE