Yamaha AM802 Bedienungsanleitung Seite 6

@ Channel Fader
This is the main level control for each input channel. lt
determines the level of the signal sent from the corre-
sponding input channel to the master stereo buss..
The settings of the input channel faders determines
the "mix" or balance of sound levels between the in-
struments or other sources connected to the inputs.
NOTE:
If a channel is not being used, its fader should be
set to the minimum position to prevent unwanted
noise from being added to the main program sig-
nals.
e Master Control Section
Ө) AUX SND Controls
These adjust the overall output level of the AUX 1,
AUX 2 and AUX 3 "mixes" set up using the corre-
sponding channel AUX controls. AUX SND 1 sets the
overall level of the AUX 1 mix signal appearing at the
AUX SND 1 jack, AUX SND 2 sets the overall level of
the AUX 2 mix signal appearing at the AUX SND 2
jack, and AUX SND 3 sets the overall level of the
AUX 3 mix signal appearing at the AUX SND 3 jack.
These controls should be used to optimally match the
AUX SND output level of the mixer to the input sensi-
tivity of the external signal processing device or power
amplifier used.
© АУХ RTN Controls
These controls adjust the level of the signal received
at the corresponding rear-panel AUX RTN jacks and
mixed into the main program on the master stereo
buss. Stereo inputs are provided for each AUX RTN
input, providing compatibility with the many mono-in/
stereo-out signal processors currently available.
Ф STEREO L & R Faders
The STEREO L and STEREO R faders independently
adjust the level of the signal sent from the left and
right master stereo busses to the L and R ST OUT
jacks. |
® PHONES Control
Adjusts the level of the master stereo program signal
applied to the rear-panel PHONES jack. Use the
PHONES control to set the most comfortable head-
phone monitoring level.
Ф REC OUT Control
This control adjusts the level of the master stereo
signal available at the rear-panel REC OUT L and R
jacks. When the REC OUT L and Н jacks are con-
nected to the inputs of a tape recorder, the REC OUT
control can be used to set the optimum recording
level (in conjunction with the tape recorder's record
level controls, if available).
Ф Level Meters
Тһе АМ802 features independent 5-element LED
peak level meters for the left and right channels. The
LED elements correspond to levels of —20, —10, -3, 0,
and +3 dB. If either of the +3 dB elements lights more
than just occasionally on high-level peaks, the fader
levels or levels of the sources connected to the
mixers inputs should be reduced to prevent possible
overload distortion.
Ф POWER Switch (Rear panel)
Flip to the ON position to turn power ON, or to the
OFF position to turn power OFF. The POWER indica-
tor LED will light when the power switch is turned ON.
CAUTION:
Make sure the STEREO L and Н faders are set to
minimum when turning the POWER switch ON.