Werbung
Verfügbare Sprachen
Verfügbare Sprachen
|
|
|
= CONTROLS
e Input Channels
О MIC/LINE Switch (Rear Panel)
— Channels 1 through 6.
This switch sets the input sensitivity of the corre-
sponding input to match line-level or microphone-level
input sources. If you will be connecting a line-level
source
such
as an
electronic
keyboard
or audio
equipment, set the switch to LINE. If you will be con-
necting a microphone or other low-level source, set
the switch to MIC.
€ GAIN Control — Channels 1 through 6.
This control adjusts the input sensitivity of the corre-
sponding input channel. Continuously variable gain
control allows optimum
matching with virtually any
microphone or line source.
Q CLIP LED — Channels 1 through 6.
The CLIP LEDs provided on channels 1 through 6 will
light if the
signal
in the
corresponding
channel
reaches a level 3-dB below clipping. If a CLIP indica-
tors lights more than just occasionally on high-level
peaks, the GAIN control level or level of the source
connected to the mixer's input should be reduced to
prevent possible overload distortion.
Q EQ LO & HI Controls
These controls permit individually modifying the re-
sponse of each channel. The НІ and LO EQ controls
function as follows:
боло! | Range | Fes | Туре |
Shelving
LO |
+15 dB
100 Hz
Shelving
ШЕ
! IN
UT
1111
ПНЕ
ІТ
NE
RESPONSE
At LI uu Lr.
г TIU
Ө AUX Controls `
© PAN Control
The PAN controls assign the signal from the corre-
sponding channel to any desired position in the "ste-
reo sound field." If a PAN control is set to the maxi-
mum "L" (LEFT) position, the signal from that channel
will appear only at the left-channel output (ST OUT L).
If the PAN control is set fully "R" (RIGHT), the signal
will appear only at the ST OUT В output jack. If a
PAN control is set to its center position, then the sig-
nal from that channel will appear equally at both the
. left- and right-channel outputs, and the sound will
appear at the center of the stereo sound field (at a
point midway
between
the two
stereo
speakers).
Other PAN control settings place the sound at posi-
tions roughly corresponding to the PAN control setting
by varying the level of the signal sent to the left- and
right-channel outputs.
`
RIGHT
SPEAKER
NZ
N
2
Se
ni,
AS
РЫ
'
Werbung
