Master Lock Sentry Safe Fire-Safe Benutzerhandbuch Seite 9

Operating Light/Sound Features
How to operate the light
The safe you have purchased may include
a long-last LED interior light. Not all safes
include a light.
The batteries that operate the keypad are
the same batteries that operate the light.
If the light in your unit does not turn on,
please change your batteries. Refer to page
5 to change the batteries.
The light will turn on every time you enter your code and will remain on
for 30 seconds. The light duration has three options – off, 30 seconds,
and 60 seconds.
To turn the light off:
Press "0" on the keypad.
1
Press "P" on the keypad.
2
Press "3" on the keypad.
3
To turn the light on for 30 seconds:
Press "0" on the keypad.
1
Press "P" on the keypad.
2
Press "4" on the keypad.
3
To turn the light on for 60 seconds:
Press "0" on the keypad.
1
Press "P" on the keypad.
2
Press "5" on the keypad.
3
NOTE: • If the light duration is 60 seconds, the battery life
will be reduced at a faster rate.
Operating sound features
For Programmable Electronic Lock Only
The tones of the keypad may be turned on and off depending on user
preference.
Turn sound off:
Press "O"on the keypad.
1
Press "P" on the keypad.
2
Press "1"on the keypad.
3
Turn sound on:
Press "O"on the keypad.
1
Press "P" on the keypad.
2
Press "2"on the keypad.
3
6
Bolting Down Your Safe
Bolt-down instructions
Bolt-down kit contents (in select models only):
• 2 lag screws
• 2 gasket washers
• 2 masonry anchors
Tools needed to bolt safe to the floor:
• Drill
• Wrench
• 11mm drill bit – for drilling into the safe
• 7mm drill bit – for drilling into a wood floor
• 13mm drill bit – for drilling into a masonry floor
Warning: • DO NOT drill from any location inside the safe.
• DO NOT bolt through the walls.
1
2
3
4
Move the safe aside to clear both marked
5
spots for drilling.
Drill into the floor:
6
F
F
Tip the safe onto its right side (door
hinges horizontal with the floor).
Unlock the safe and open the door.
Turn the safe on its side so the bottom
of the safe is accessible. Using the
11mm bit; drill a hole through two
perpendicular feet on the bottom of
the safe. DO NOT drill from any
location inside the safe.
Tip the safe upright, place the safe in
the desired location and open the door.
Use a screw or pencil to mark the floor
through both holes.
A. For wood: Using the 7mm drill
bit, drill a hole 60mm deep in each
marked spot.
B. For masonry: Using the 13mm drill
bit, drill a hole 60mm deep in each
marked spot. Install
a masonry
anchor in each hole.