Master Lock Sentry Safe Fire-Safe Benutzerhandbuch Seite 8

Programmable Electronic Lock
Programming information
Three code options:
Factory code:
The safe will ALWAYS unlock using this
5 digit code (found on the back of the
owner's manual). This code cannot be
deleted.
User code:
A 5 digit programmable code of your choosing that can be changed
or deleted.
Secondary code:
Up to 3 secondary 5 digit programmable codes can be changed or
deleted. A secondary can only be programmed after a user code has
been activated.
NOTE: • The "C" key is a clear key. This can be used at anytime to clear
the system and return to standby mode – unless you are in
delay mode (3 consecutive invalid entries).
• The 5 digit factory code cannot be deleted. However, you may
add and delete additional codes.
This safe can store up to five codes at one time. One factory
code and 4 additional programmable codes.
Programming the user code
To ADD a user code:
Press "P" on the keypad.
1
Enter the 5 digit factory code found on the back of your
2
owner's manual.
The light will flash green and then you will have five
3
seconds to enter your own personal 5 digit user code.
To DELETE a user code:
Press "P" on the keypad.
1
Enter the 5 digit factory code.
2
Enter 0,0,0,0,0.
3
NOTE: • The electronic lock will NOT indicate that it has deleted the
user code – please test the code to make sure it has been
deleted.
Programming the secondary code
To ADD a secondary code:
Press "P" on the keypad two time.
1
Enter the 5 digit user code previously programmed.
2
The light will flash green and then you will have five
3
seconds to enter your own personal 5 digit secondary
code.
Repeat steps 1-3 in order to add an additional
4
secondary code.
To DELETE a secondary code:
Press "P" on the keypad two time.
1
Enter the 5 digit user code.
2
Enter 0,0,0,0,0.
3
Repeat steps 1-3 in order to delete an additional
4
secondary code.
NOTE: • The electronic lock will NOT indicate that it has deleted the
secondary code – please test the code to make sure it has
been deleted.
• Secondary codes will be deleted in the order they were
programmed.
Changing your batteries
Locate the battery pack compartment
1
on the inside of the door
and remove the cover.
Insert two CR123 lithium batteries.
2
Replace battery pack cover.
3
NOTE: • Do not use rechargeable batteries or any other type of
non- CR123 lithium battery. Do not mix old and new batteries.
Battery auxiliary override
If battery power in the safe is running low and cannot operate the safe,
you will need to use the battery auxiliary override feature to open the
safe.
IMPORTANT: This should not be used as a primary means to gain
entry into the safe.
Open the silicone cap found on the side
1
of the lock.
Pull out the wire inside the lock and
2
attach a 9 volt battery.
Enter your five digit code.
3
Pull handle outward to open the door.
4
5