Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Replace the safe in the desired position, with the holes in the safe aligned with those in the floor.
7
Securing the safe:
8
A. For wood: Pass each lag screw through a washer, then through the safe and into a hole. Tighten with
B. For masonry: Pass each lag screw through a washer, then through the safe and into a masonry anchor.
NOTE: • The safe should not be bolted to a wall, this will compromise the fire rating.
F
F
Not all SentrySafe products come with a bolt-down kit.
Please go to www.sentrysafe.com to learn more about the recommended hardware for your safe.
Troubleshooting
The Problem:
The door will not close and lock.
After inputting the programmable
code, the door does not open.
Red indicator light blinks three
times and there are three beeps.
Red indicator light blinks five
times and there are five beeps.
Red indicator light blinks once and
there is one beep.
Red indicator light is blinking.
Yellow indicator light is on.
the wrench.
Tighten with the wrench.
Drill holes through the feet only. DO NOT drill through the back or sides.
• Bolting/unbolting the unit is at the consumer's expense and discretion.
• SentrySafe / Master Lock is not responsible for any costs incurred if the unit is to be replaced.
• When bolting down, ensure the gasket washer is facing down.
• If rubber pads are in place, remove them before drilling.
Why it is Happening:
1. Confirm that there is no obstruction in the
door.
2. Bolted down incorrectly.
1. Battery Power may be low.
2. May be the wrong battery ype.
An incorrect code has been entered.
Keypad communication error.
1. Program button is pressed out of sequence.
2. 5 seconds has lapsed between button entries.
An incorrect code has been entered three times
and system has entered delay mode.
1. Battery power is low.
2. Battery may be the wrong type.
The Solution:
1. Remove all items and accessories from inside the safe. If
this resolves the issue, re-set the accessories and organize
items to properly fit.
2. See pages 6-7 for proper bolt-down instructions.
1. Use override key to open the safe and replace batteries.
2. Use 9 volt battery to open your safe and replace the
batteries.
Verify code and re-enter. If the programmable code you are
using does not work then use the factory code. If successful
re-program your programmable code.
Contact our customer service
Start over.
Wait two minutes and start over.
Replace with new CR123 lithium batteries.
7
Werbung
