Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATIoN
Installation
9.2
Completing the installation
f Fit the lower part of the back panel. Ensure that it clicks into
f
place.
f Align the mounted appliance by loosening the fixing toggle,
f
aligning the electrical connection and back panel, and then
retightening the fixing toggle. If the back panel of the appli-
ance is not flush, the appliance can be secured at the bottom
with an additional screw.
9.3
Alternative installation methods
- Electrical connection from above for unfinished walls
- Electrical connection for finished walls
- Large cross-section for electrical connection from below
- Connecting a load shedding relay
- Water installation for finished walls
- Water installation for finished walls with solder / compres-
sion fitting
- Water installation for finished walls, fitting the appliance
cover
- Installation of lower part of back panel with threaded fitting
for finished walls
- Use of existing wall mounting bracket when replacing an
appliance
- Installation with offset tiles
- Operation with preheated water
Electrical connection from above for unfinished walls
f Cut open the cable grommet for the power cable.
f
26
| DHE SL LABS
f Push down the locking hook that secures the mains terminal,
f
then remove the mains terminal.
f Reposition the mains terminal in the appliance from the
f
bottom to the top and secure the mains terminal by sliding it
under the locking hook.
f Route the control wires below the wire guide.
f
Power cable for finished walls
f Cut or break out the required entries in the back panel and
f
appliance cover cleanly (for positions, see chapter "Specifica-
tion / Dimensions and connections"). If necessary, use a file.
f Route the power cable through the cable grommet and con-
f
nect it to the mains terminal.
Note
This type of connection changes the protection rating of
the appliance.
f Change the type plate. Cross out "IP 25" and mark
f
the box "IP 24". Please use a ballpoint pen to do this.
Large cross-section for electrical connection from below
If cables with a large cross-section are used, the cable grommet
can be fitted after the appliance has been installed.
1.
3.
f Before installing the appliance, use a screwdriver to push the
f
cable grommet out.
f Push the cable grommet over the power cable. For this, use
f
the installation aid. In the case of a cross-section > 6 mm²,
enlarge the hole in the cable grommet.
f Push the cable grommet into the back panel.
f
2.
4.
www.stiebel-eltron.com
Quicklinks ausblenden:
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
