Herunterladen Diese Seite drucken

Husqvarna 525HF3S Bedienungsanweisung Seite 14

Vorschau ausblenden Andere Handbücher für 525HF3S:

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 75
c) Make sure that the air filter is clean.
If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, refer to
on page 16 .
Replace the spark plug if it is necessary.
Air filter
Remove dust and dirt from the air filter to keep it clean
and prevent these problems:
Carburetor malfunctions.
Problems when you start the product.
Loss of engine power.
Increased wear to engine parts.
Too much fuel consumption.
To clean the air filter
CAUTION:
very dirty, or soaked with fuel must always
be replaced.
Clean the air filter from dirt and dust regularly. This
prevents carburetor malfunctions, starting problems,
loss of engine power, wear to engine parts and more
fuel consumption than usual.
If you use an air filter for a long time, it cannot be fully
cleaned. Replace the air filter with a new one at regular
Maintenance on page 11 .
intervals. Refer to
1. Move the choke lever up to close the choke valve.
14
Technical data
An air filter that is damaged,
2. Remove the air filter cover and the air filters.
3. Clean the air filters with warm soap water.
4. Replace the air filters if they cannot be fully cleaned.
Always replace a damaged air filter.
5. Clean the inner surface of the air filter cover. Use
compressed air or a brush.
6. Do a check of the rubber seal on the air filter.
Replace the air filter if the rubber seal is damaged.
7. Make sure that the air filter is dry before you install it.
To apply oil to the foam air filter
CAUTION:
special air filter oil. Do not use other types
of oil.
WARNING:
The air filter oil can cause skin irritation.
1. Put the foam air filter in a plastic bag.
2. Put the oil in the plastic bag.
3. Rub the plastic bag to supply the oil equally across
the foam air filter.
4. Push the unwanted oil out of the foam air filter while
in the plastic bag.
To lubricate the gear housing
WARNING:
housing immediately after operation of the
product. The gear housing is hot and can
cause injury.
Always use Husqvarna
Put on protective gloves.
Do not touch the gear
1118 - 005 - 29.08.2023

Werbung

loading