Husqvarna 525HF3S Bedienungsanweisung Seite 11

Note:
To start the product when the engine is warm, it
is not necessary to use the choke control.
To stop the product
• Move the stop switch to the stop position to stop the
engine.
CAUTION:
automatically goes back to run position.
To operate the product
• Start near the ground and move the product up
along the hedge when you cut the sides.
Introduction
WARNING:
safety chapter before you do maintenance
on the product.
Maintenance schedule
Maintenance
Clean the external surface.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted
lubricant.
Make sure that the cutting unit does not move at idle speed.
1118 - 005 - 29.08.2023
The stop switch
Maintenance
Read and understand the
• Adjust the speed to align with the work load.
• Make sure that the engine does not touch the hedge.
• Hold the product near your body for a stable work
position.
• Make sure that the tip of the cutting equipment does
not touch the ground.
• Be careful and work slowly until all the branches are
correctly cut.
operation
Before After 40 After 100
h
After each operation.
After each operation.
X
h
11