Quickstart - Beurer SensEpil HL 100 Gebrauchsanleitung

Quick Start
SensEpil™ by beurer Setup
1. Remove SensEpil™ by beurer and other components from box.
BASE UNIT, APPLICATOR
2. Verify that the is inserted correctly into the .
DISPOSABLE LAMP CARTRIDGE APPLICATOR
3. Plug the power cord into the SensEpil™ by beurer socket.
BASE UNIT
4. Plug the other end of the power cord into an electrical outlet. The will turn on.
STAND BY INDICATOR LIGHT
Your SensEpil™ by beurer is now ready to start.
Treating with SensEpil™ by beurer for the fi rst time
The skin should be shaved, clean, dry and free of any powders, antiperspirants or deodorants.
5. Press the . The will turn on and a fan sound (similar to the
POWER ON/STANDBY SWITCH POWER ON INDICATOR LIGHT
sound of a hairdryer) will start.
6. Approximately 4 seconds after pressing the , the will turn on and
POWER ON/STANDBY SWITCH READY INDICATOR LIGHT
the device will beep. The device sets itself to deliver the lowest energy level pulses. The device is then ready
for you to trigger the fi rst pulse.
7. The energy level should be higher than the lowest, press the using the "-" or "+"
ENERGY LEVEL SETTING BUTTONS
to respectively decrease or increase the energy level, until the desired energy level is set.
ENERGY LEVEL INDICATOR
will coincide with the energy level setting. (See "Energy Level" frame).
LIGHTS
8. Apply the fi rmly to the skin, making sure the skin is spread evenly and smoothly. Make sure the
APPLICATOR
is in full contact with the skin.
APPLICATOR TIP
9. Press the . The device will fi rst determine the color of your skin. If the color of the skin is light
PULSE BUTTON
enough for safe application, the device will fl ash a pulse of light onto your skin. You will see a bright fl ash of
light and simultaneously hear a subtle pop sound, which is a normal noise for the device. You may feel a mild
sensation of warmth and tingling. SensEpil™ by beurer will immediately recharge for the next pulse. After
3.5 seconds the will turn on again and the device will beep.
READY INDICATOR LIGHT
10. Remove the from the treated area of skin.
APPLICATOR TIP
11. Move the to another area of skin. Use the pressure marks the device just made on your skin
APPLICATOR TIP
to guide you for proper positioning of the next pulse, avoiding both gaps and overlaps between pulses (See
"Covering skin areas" frame).
12. Repeat the process starting again with Step 5.
43