What To Expect When Treating With Sensepil™ By Beurer - Beurer SensEpil HL 100 Gebrauchsanleitung

SensEpil™ by beurer pulses should be administered in rows, starting at one end of each row
and progressing sequentially towards the other end. This technique allows better control of skin
coverage, and helps you avoid treating the same area more than once or overlapping skin areas.
When applied to the skin, the SensEpil™ by beurer
pressure marks on the treated area. These visible marks can be used for proper positioning of
the next pulse.
Try to avoid overlapping pulses!
Do not treat the same area of skin more than once per hair removal session!
If your skin blisters or burns, STOP USE IMMEDIATELY!
10.3. What to Expect when treating with SensEpil™ by beurer?
For many people, using SensEpil™ by beurer may be their fi rst experience with a light-based device designed for home use.
SensEpil™ by beurer is simple to use, and hair removal sessions go by quickly. During a SensEpil™ by beurer session it is
normal to experience and feel:
A Fan Noise – The cooling fan in SensEpil™ by beurer makes noise similar to a hairdryer. This is normal.
A Pop Sound with Each Pulse – When a pulse of HPL™ light is activated, it is normal to hear a subtle pop sound
simultaneously with the fl ash of light.
Moderate Pressure of the
of the unique safety feature of SensEpil™ by beurer.
A Sensation of Warmth and Tingling – During each pulse of light it is normal to feel a mild sensation of warmth and
tingling from the light energy.
Remember it is important to always use low energy settings for initial hair removal sessions. You may feel some warmth
for up to an hour after your SensEpil™ by beurer session.
Some Mild Red or Pink Color – During and just after your SensEpil™ by beurer session it is not uncommon to see some
very mild, pink-like color of the skin. This is usually most noticeable around the hairs themselves. However if you see full
redness of the skin, blistering or burns stop use of SensEpil™ by beurer immediately.
Covering skin areas
APPLICATOR TIP
– This is necessary and helpful for placement of adjacent pulses of light, and is part
APPLICATOR
is designed to create temporary
37