Beurer SensEpil HL 100 Gebrauchsanleitung Seite 36

Energy Level
Energy level determines the intensity of the SensEpil™ by beurer light pulse delivered to your skin, from the lowest level
(-) to the highest level (+). Corresponding
energy level increases, so does hair removal results as well as the risk of possible side effects and complications.
Always start your fi rst SensEpil™ by beurer hair removal session at the lowest energy setting.
If you experience little or no discomfort during and after the hair removal session using the lowest energy level, raise
the energy level by one
Do not raise the energy level if you experience abnormal discomfort during or after treating with
SensEpil™ by beurer! (See "Possible Side Effects")
Do not raise the energy level during hair removal session even if you experience no discomfort.
Discomfort may also appear some time after the session.
Whenever SensEpil™ by beurer is turned on its energy level will automatically be reset to the lowest energy level. Only
one
ENERGY LEVEL INDICATOR LIGHT
To set the energy level, press the
energy level. The number of
For your safety, when using SensEpil™ by beurer for the very fi rst time, the system is automatically set to deliver the fi rst
50 pulses at the lowest energy level, and the next 200 pulses at up to level 3.
To cancel these safety settings press and hold the "+" and "-"
hear 2 consecutive "beep" sounds.
To restore these safety settings press and hold the "+" and "-"
hear 3 consecutive "beep" sounds.
Light-based hair removal on darker skin tones can result in adverse effects such as burns, blisters, and skin color changes
(hyper- or hypo-pigmentation).
To prevent such misuse, a unique
beginning of each session and occasionally during the session. If the
for SensEpil™ by beurer application, the device will automatically stop emitting pulses.
If you see no light pulse and the
tone, measured by the
SKIN COLOR SENSOR
contact the SensEpil™ by beurer support.
36
INDICATOR LIGHTS
at the next session, and so on for each subsequent session.
INDICATOR LIGHT
will be on.
ENERGY LEVEL SETTING BUTTONS
ENERGY LEVEL INDICATOR LIGHTS
The Skin Color Sensor
in SensEpil™ by beurer measures the treated skin complexion at the
SKIN COLOR SENSOR
SKIN TONE WARNING INDICATOR LIGHT
, is too dark for safe application. Try using the device on a different body part or
on the represent the increases in energy. As
CONTROL PANEL
using "-" or "+" to respectively decrease or increase the
will coincide with the change in energy level.
ENERGY LEVEL SETTING BUTTONS
ENERGY LEVEL SETTING BUTTONS
detects a skin tone that is too dark
SKIN COLOR SENSOR
blink for 3 seconds, this is an indication that your skin
simultaneously until you
simultaneously until you