First Steps With Sensepil™ By Beurer; Sensepil™ By Beurer Setup; Treating With Sensepil™ By Beurer For The Fi Rst Time - Beurer SensEpil HL 100 Gebrauchsanleitung

10. First steps with SensEpil™ by beurer
10.1. SensEpil™ by beurer Setup
1. Remove SensEpil™ by beurer
2. Verify that the
DISPOSABLE LAMP CARTRIDGE
3. Plug the power cord into the SensEpil™ by beurer
4. Plug the other end of the power cord into an electrical outlet. The
will turn on.
Your SensEpil™ by beurer is now ready to start.
10.2. Treating with SensEpil™ by beurer for the fi rst time
The skin should be shaved, clean, dry and free of any powders, antiperspirants or deodorants.
5. Press the
POWER ON/STANDBY SWITCH
hairdryer) will start.
6. Approximately 3.5 seconds after pressing the
beep. The device sets itself to deliver the lowest energy level pulses. The device is then ready for you to trigger the fi rst pulse.
7. If the energy level should be higher than the lowest, press the
decrease or increase the energy level, until the desired energy level is set.
energy level setting. (See "Energy Level" frame).
8. Apply the fi rmly to the skin, making sure the skin is spread evenly and smoothly. Make sure the
APPLICATOR
full contact with the skin.
9. Press the The device will fi rst determine the color of your skin.
.
PULSE BUTTON
If the color of the skin is light enough for safe application, the device will fl ash a pulse of light onto your skin. You will see a bright
fl ash of light and simultaneously hear a subtle pop sound, which is a normal noise for the device. You may feel a mild sensation
of warmth and tingling.
SensEpil™ by beurer will immediately recharge for the next pulse. After 3.5 seconds the
and the device will beep.
If you see no light pulse and the
the , is too dark for safe application. Try using the device on a different body part or contact the
SKIN COLOR SENSOR
SensEpil™ by beurer support (See: "The Skin Color Sensor" frame).
10. Remove the TIP from the treated area of skin.
APPLICATOR
11. Move the TIP to another area of skin.
APPLICATOR
Use the pressure marks the device just made on your skin to guide you for proper positioning of the next pulse, avoiding both gaps
and overlaps between pulses (See "Covering skin areas" frame).
Warning: Do not treat the same area of skin more than once per hair removal session! Treating the same area of skin
more than once per session increases the likelihood of adverse effects.
12. Repeat the process starting again with Step 5.
and other components from box.
BASE UNIT, APPLICATOR
is inserted correctly into the
BASE UNIT
. The
POWER ON INDICATOR LIGHT
POWER ON/STANDBY SWITCH
ENERGY LEVEL SETTING BUTTONS
SKIN TONE WARNING INDICATOR LIGHT
.
APPLICATOR
socket.
STAND BY INDICATOR LIGHT
will turn on and a fan sound (similar to the sound of a
, the
READY INDICATOR LIGHT
using the "-" or "+" to respectively
ENERGY LEVEL INDICATOR LIGHTS
READY INDICATOR LIGHT
blink for 3 seconds, your skin tone, measured by
will turn on and the device will
will coincide with the
is in
APPLICATOR TIP
will turn on again
35