Troubleshooting; My Sensepil™ By Beurer Does Not Start; A Light Pulse Is Not Emitted When I Press The Pulse Switch - Beurer SensEpil HL 100 Gebrauchsanleitung

Note: A DISPOSABLE LAMP CARTRIDGE should also be replaced if large spots appear inside it or if
its LENS is broken.
To replace a
DISPOSABLE LAMP CARTRIDGE
1. Press the
POWER ON/OFF SWITCH
2. Unplug the power cord from the electrical outlet.
3. Grasp the used
DISPOSABLE LAMP CARTRIDGE
discard with normal trash.
4. Unwrap a new
DISPOSABLE LAMP CARTRIDGE
5. Push the new
DISPOSABLE LAMP CARTRIDGE
If correctly installed, the
DISPOSABLE LAMP CARTRIDGE
released.

12. Troubleshooting

12.1. "My SensEpil™ by beurer does not start"
Make sure the power cord is properly connected to the SensEpil™ by beurer device.
Make sure the power cord is plugged into an electrical outlet on the wall.
12.2. "A light pulse is not emitted when I press the
Make sure that you have good contact with the skin and that the
safety, the will activate a pulse only if the
PULSE BUTTON
Check the . If the
CONTROL PANEL
measured by the
SKIN COLOR SENSOR
the SensEpil™ by beurer support.
Check the
REPLACE CARTRIDGE INDICATOR LIGHT
.
CARTRIDGE
Make sure that the
READY INDICATOR
If within 10 seconds the
twice.
ON/OFF SWITCH
Check the
SYSTEM WARNING INDICATOR LIGHT
If the light is on turn SensEpil™ by beurer off and back on by pressing the
Do not attempt to open or repair your SensEpil™ by beurer device.
Opening SensEpil™ by beurer may expose you to dangerous electrical components and to pulsed light energy, either of which
may cause serious bodily damage and/or permanent eye injury.
Trying to open SensEpil™ by beurer may also damage the device and will void your warranty.
:
to turn SensEpil™ by beurer off.
on both sides, pull it out of the socket and
.
gently into place.
will spring back when pushed in and
PULSE SWITCH
APPLICATOR TIP
SKIN TONE WARNING INDICATOR LIGHT
, is too dark for safe application. Try using the device on a different body part or contact
. If it is on, disconnect SensEpil™ by beurer and replace the
is on.
remains off turn SensEpil™ by beurer off and back on by pressing the
READY INDICATOR
.
"
is evenly and fi rmly pressed to the skin. For your
APPLICATOR TIP
is fi rmly pressed against the skin.
blink for 3 seconds, this is an indication that your skin tone,
POWER ON/OFF SWITCH
DISPOSABLE LAMP
POWER
twice.
39