Herunterladen Diese Seite drucken

Singer S010L Bedienungs- Und Sicherheitshinweise Seite 25

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Remove
Remove
Fold the fabric layers with the reverse sides facing and sew.
Press all pin-tucks in the same direction.
Sewing corners
Outside corners
Cut off to about 2 cm from the stitch line before and after the corner.
Sew one stitch beyond point A and stop.
Raise the needle and presser foot.
Pull the fabric straight back hard enough for the thread on the stitch
finger to release.
Note: the presser foot was omitted from the drawing for a better view
of the details.
Turn the fabric and lower the presser foot so the knife is in line with the
cutting edge.
Pull the loose threads up and sew.
Cutting line
A
2cm
2cm
Inside corners
Trim the fabric along the edge.
Bring the upper knife to the rest position.
Sew on the cutting edge.
Stop before reaching the corner. Make a fold at the corner to align the
two fabric edges.
Slowly continue sewing and stitch the second edge past the corner. Do
not include the fold.
347907_BE 25
Cutting line
Cutting line
Inserting pins
Insert pins to the left of the presser foot.
This ensures the pins are not within the
cutting area of the blade and are later
easy to remove.
CAUTION! Sewing over the pins will
result in partly irreparable damage to
the knife blades.
Securing the thread chain
Thread the thread chain into a hand needle with a large eye (e.g.
embroidery needle).
Insert the needle into the end of the seam to secure.
Note: for more information on securing a rolled hem please refer to
„Securing the rolled hem thread chain".
Reinforced seam
Sewing in hem tape whilst overlocking will make the seam more durable.
Guide the tape through the slit at the front of the presser foot.
Place the tape under the foot toward the back and sew the seam.
The tape will be attached with the seam.
Sewing edging
Bring the upper knife to the rest position.
Feed wool yarn or tape through the slit at the front of the presser foot.
Place the tape or wool yarn under the presser foot and chain off the
desired length.
Chained off edging can be used individually or braided in multiples.
GB/IE
25
24-Apr-2020

Werbung

loading