Omnitronic SPL-1 Bedienungsanleitung Seite 23

8 Indicator outputs
RJ45 jacks, connected in parallel, for connecting the
external warning indicators via standard network cables
(not included).
9 Microphone input
6.3 mm jack for connecting the supplied measurement
microphone.
10 Line inputs
Balanced XLR inputs for connecting the signal source
(mixer or controller).
11 Line outputs
Balanced XLR outputs for connecting a subsequent PA
amplifier. The volume-controlled audio signal is present at
these jacks. When muting is activated the outputs will be
shut off for 30 seconds.
12 Power input with fuseholder
Used to plug the supplied power cord in. Only replace the
fuse when the device is disconnected from the mains.
Only use fuses of the same rating and power. The correct
fuse value is specified on the rear panel.
23/30 00051963.DOC, Version 1.0