Stihl HLE 71 Gebrauchsanleitung Seite 31

On units with adjustable cutter bar:
–
Make sure the adjuster is properly
engaged in the required position for
starting.
On units with a defined transport
–
position (cutter bar folded against
drive tube): Never operate the unit
in the transport position.
Never attempt to modify the controls
–
or safety devices in any way.
Keep the handles dry and clean –
–
free from oil and dirt – for safe
control of the power tool.
Adjust shoulder strap and handles
–
to suit your height and reach. See
chapter on "Fitting the Harness".
To reduce the risk of personal injury, do
not operate your power tool if it is
damaged or not properly assembled.
If you use a shoulder strap or full
harness: Practice removing and putting
down the power tool as you would in an
emergency. To avoid damage, do not
throw the machine to the ground when
practicing.
To reduce the risk of electric shock:
Always connect the power tool to a
–
properly installed wall outlet.
Make sure the extension cord used
–
complies with the regulations for the
intended application.
Check that the insulation of the
–
power cord, extension cord, plug
and coupling is in good condition.
Holding and Controlling the Power Tool
Always hold the power tool firmly with
both hands on the handles.
HLE 71, HLE 71K
Right hand on control handle, left hand
on loop handle on drive tube, even if you
are left-handed. Wrap fingers and
thumbs firmly around the handles.
Make sure you have firm and secure
footing and hold the power tool so that
the cutting blades are always away from
your body.
Some versions of the machine can be
carried on a harness to relieve the
weight on the operator's arms.
During Operation
In case of imminent danger or in an
emergency, switch off the motor
immediately – release the trigger switch
and starting lockout.
To reduce the risk of
electrocution, keep well
clear of electric power
lines.
To reduce the risk
of injury from
moving blades or
5m (17ft)
falling cuttings, do
not allow
bystanders within
5 meters of your own position. To
reduce the risk of damage to property,
also maintain this distance from other
objects (vehicles, windows).
Watch the cutting blades at all times – do
not cut areas of the hedge that you
cannot see.
Be extremely careful when cutting tall
hedges, check the other side of the
hedge before starting work.
The drive motor is not
waterproof. To reduce
the risk of a short circuit
or electrocution, never
work with the power tool
in the rain or in wet or
very damp locations.
Do not leave the machine outdoors in
the rain.
Take special care in slippery conditions,
on slopes or uneven ground.
Clear away fallen branches, scrub and
cuttings.
Watch out for obstacles: Roots, tree
stumps or holes which could cause you
to trip or stumble.
Make sure you always have good
balance and secure footing.
When working at heights:
Always use a lift bucket
–
Never work on a ladder
–
Never work on an insecure support
–
Never operate your power tool with
–
one hand
Be particularly alert and cautious when
wearing hearing protection because
your ability to hear warnings (shouts,
alarms, etc.) is restricted.
English
29