Werbung
Verfügbare Sprachen
Verfügbare Sprachen
around the appliance for the dissipa-
tion of heat. For this reason, sufficient
clear space should be available
around the refrigerator.
Suggest: It is advisable for there to be
50-70mm of space from the back to
the wall, at least 100mm from its top,
at least 100mm from its side to the
wall and a clear space upfront to allow
the doors to open 135°.As shown in
follow diagrams.
Warning: This appliance must be
grounded. The manufac-
turer declines any liabil-
ity should these safety
measure not be ob-
served
Reversing the
door
The side at which the door opens can
be changed from the right side (as
supplied) to the left side, if the instal-
lation site requires.
Tools you will need:
8mm socket driver
Cross-shaped screwdriver
Putty knife or thin-blade screwdriver
Before you start lay the refrigerator
on it's back to gain access to the base,
you should rest it on soft foam pack-
aging or similar material to avoid dam-
aging the cooling pipes at the rear of
the refrigerator.
1.
Open the appliance door and un-
hinge and remove all fittings
from inside the appliance.
2.
Unscrew the 2 screws (10). (Re-
frigerator with cover panel)
3.
Take off the cover panel (11) and
set it down on a soft surface. (Re-
frigerator with cover panel)
4.
Remove the upper hinge cap (7).
(Refrigerator
panel)
5.
Remove the two screws blot (6)
that connect the upper hinge (5)
on the right side of the cabinet
top.
without
cover
Werbung
