Horizon Hobby parkzone Stinson Reliant SR-10 BNF/PNP Bedienungsanleitung Seite 6

EN
General Assembly and Maintenance Tips
Note: This checklist is not a replacement for the content included in this manual. Although it can be used as a quick start guide, we
strongly suggest reading through this manual completely before proceeding.
First Flight Preparation

Remove and inspect contents
Begin charging flight battery
Assemble Stinson Reliant
Install receiver
Connect servos to receiver or Y-harness
Install fully charged battery
Bind the receiver to a transmitter, if applicable
Perform the Control Direction Test with the transmitter
Adjust flight controls and transmitter
Adjust battery for center of gravity (CG) see page 9
Perform a radio system Range Check
Find a safe and open flying field
Plan flight for flying field conditions
Maintenance After Flying

Disconnect flight battery from ESC (Required for Safety)
Turn off transmitter (Required for Safety)
Remove flight battery from aircraft
Recharge flight battery
Clean aircraft (wipe off dirt, etc.)
Repair or replace all damaged parts
Carefully disassemble and store aircraft
Store flight battery apart from aircraft and monitor the battery charge
Make note of flight conditions and flight plan results, planning for future flights
Installing Pushrods on Control Horns
Tip: T urn the clevis clockwise or counterclockwise
on the pushrod. Make sure transmitter trims are
centered before making this adjustment.
• Pull the elastic band from the clevis to the
pushrod.
• Carefully spread the clevis and put the clevis
pin in a selected hole in the control horn.
• Move the elastic band to hold the clevis on
the control horn.
6
Activity
Activity
1.
2.
3.
PNP
u
u
u
u
u
u
u
u
u
u
u
u
u
PNP
u
u
u
u
u
u
u
u
u
4.
5.
6.
BNF
u
u
u
u
u
u
u
u
u
u
u
u
BNF
u
u
u
u
u
u
u
u
u